20
Calibration and Configuration
This section discusses calibration, printing configuration and
resetting the printer to factory defaults.
Performing Calibration and Configuration
1.
Turn off the printer power.
2.
Press and hold the feed button while turning on the power,
until the printing motor is activated.
3.
Calibration is performed while the printer automatically feeds
the label stock for a certain length, the printing motor
suspends for one second and then prints out a configuration
profile.
4.
The profile includes firmware version, ROM checksum,
RS-232, thermal transfer/direct thermal settings, hardware
configuration, and font types.
5.
At PPLB emulation, the printer enters character dump mode.
To exit from dump mode, press the feed button again. (If you
accidentally print the label without exiting from dump mode in
advance, you need to turn on the printer or press feed button
again to print normally.)
Important!
You must always carry out calibration when
changing media. Failure to do so will result in improper
detection by the label sensor.
Resetting to Factory Default Settings
1. Turn on the printer and wait for 5 or more seconds.
2. Press the "Feed" button for 10 seconds, and the "Ready"
indicator and "Power" indicator will go off in order.
3. When the two indicators relight, release the feed button.
4. The printer feeds approximately 3 ~5 blank labels, and
then resets to the factory defaults.
Note:
Revise the factory default settings that stored in flash,
even if turn off the power source cannot be eliminated.
21
