7-10
WSS 1000 Product Reference Guide
Typical parameters are:
38400 bps
7 bit data
Odd parity
Xon/Xoff flow control
Wrist Computer
1. Boot the wrist computer to Command Mode (refer to
for the appropriate key sequence).
2. Select the Memory Transfer function from the Command Mode menu. Use UpArrow
or DownArrow to scroll through the command mode options until Memory Transfer
is displayed, and press <ENTER>.
3. Select the range of memory to transfer by pressing the first letter of the desired range
(All, Range, or None), or use the UpArrow or DownArrow and press <ENTER>.
If you select All, the program skips to the range verification screen (step 7).
If you select Range, the screen displays:
RAM
Use Arrow Keys
Start End
00000 9FFFF
4. Specify a range of RAM by setting the Start and End addresses.
Œ
Use RightArrow and LeftArrow to move the cursor to the digit to be changed
Œ
Use UpArrow and DownArrow to change the values.
Type a range and press <ENTER>.
5. Specify a range of NVM to transfer. Choose All or None.
6. If the system has EMS installed, it prompts for the range to transfer (otherwise, the
program skips this screen):
EMS
Use arrow keys
Start End
The range is specified in page numbers (16 KB per page). Use RightArrow and
LeftArrow to move between the Start and End values. Use UpArrow and
DownArrow to change the page number value.
Summary of Contents for WSS 1000
