Symbol Series 6800, Product Reference Manual

Page: 54 / 138

4-11
Spectrum24 RF Terminal Setup
Initiating Network Connection
As the initialization continues, the terminal attempts to associate with the Spectrum24 AP
using the default or newly entered Net Id.
Series 684X Association with AP Not Successful
If the 6840 is unable to associate with the AP (the Net Id is wrong or forgotten), it displays
the message:
STAT24 Ver 1.XX
NOT Associated
for a few seconds. A second message follows:
Terminal cannot associate with AP. You’re
out of range or not configured. Ctrl+C to end
or other key to retry. Strike any key when
ready.....
The 6840 continues trying to connect until the attempt is cancelled.
1. Press <Ctrl + C> to end the attempt. The 6840 displays the message:
Halt Batch process Y/N?
2. Type Y to exit to the DOS prompt (D:).
3. At the DOS prompt, type CFG24 and press <ENTER> to initiate the Configurator
and bring up the Configurator screen.
4. Verify the Net Id with the LAN administrator to ensure you are entering the correct
value.
5. Verify other parameters and proceed as directed in the section Initializing the Series ,
beginning with step 4a.
Series 684X Association with AP Successful
If the association is successful, the terminal begins operating using the software files loaded
on the flash disk.
On first initialization, you probably don’t have applications loaded. Proceed with loading the
applications as directed in
Installing Application Software on Flash Disk . On subsequent
initializations, if only one application is loaded, that application is displayed automatically.
If you loaded multiple applications, an application selection menu is displayed early in the
initialization process. Select the application to load for the current session and proceed.