Symbol Series 6800, Product Reference Manual, Page: 47 / 138

4-4
Series 6800 Product Reference Guide
Figure 4-1. CFG24 Main Menu
On the 6840 screen, the top and bottom lines of the menu are displayed, and the
remaining lines are viewed by scrolling. In this menu, pressing <CLEAR> has the
same effect as selecting Exit.
4. The 6840 initially is set to NOBOOT mode. To configure the terminal for operation,
set up the parameters provided in Table 4-1 (the procedures are detailed in the steps
below).
Table 4-1. Spectrum24 Configuration Parameters
Net Id The Net Id identifies the radio network and differentiates
between different radio networks. All equipment on one
network must use the same Net Id.
Set to the same value specified for the Spectrum24 Access Points
(APs).
Boot Mode The boot mode indicates the source of the terminal’s IP address.
If this value is set to “Manual entry”, you must enter a terminal
IP address through CFG24.
CONFIGURATOR 1.XX
View config params
Net Id
Subnet Mask
Default Router
Terminal IP Address
Diversity
Terminal Sleep Mode
Boot Mode
Power Management
Exit
áâ
, Clear, Enter