Symbol Series 3800, Reference Manual

Page: 29 / 138

2-7
Hardware Setup
Coupling CCMs
Up to four 3860 CCMs can be coupled together for table or wall mounting, with power
provided by a single power supply attached to the left-most CCM.
To couple two or more CCMs for table or wall mounting:
1. Verify that add-on 3861-101 kit contains the following parts:
"
1 coupling bracket
"
6 cross-head screws
"
2 flat-head screws
2. On the add-on (or right-hand) CCM, use 3/16-inch driver to remove the jack screws
securing the communications port, ONE AT A TIME, and replace them with the flat-
head screws.
Note: Be sure to remove the jack screws one at a time; otherwise, the
connector will fall into the housing.
3. Place the coupler between the CCMs, aligning the holes in the coupler to the holes
in the CCM’s base (Figure 2-6).
4. Install 6 cross-head screws through the coupler into the CCMs and tighten.
5. If you wish to wall mount the coupled CCMs, proceed as directed in Wall Mounting
the CCM.
Figure 2-6. Coupling two 3860 CCMs
Coupling
Screws
Screws