Symbol MiniScan MS1204FZY, Integration Manual

Page: 115 / 260

Parameter Menus 10 - 9
Set Defaults - Symbol MS954
The Symbol MS954 is shipped with the factory default settings shown in Table 10-1 on page 10-2. These factory
default values are stored in non-volatile memory and are preserved even when the scan engine is powered down.
Changes to the factory default values can be stored as custom defaults. These values are also stored in
non-volatile memory and are preserved even when the scanner is powered down.
•
Scan the appropriate bar code below to reset the Symbol MS954 to its default settings and/or set the
scanner’s current settings as the custom default.
•
Restore Defaults - Scan this bar code to reset all default parameters as follows.
• If custom defaults were set by scanning Write to Custom Defaults , scan Restore Defaults to retrieve
and restore the scan engine’s custom default settings.
• If no custom defaults were set, scan Restore Defaults to restore the factory default values listed in Table
8-1 on page 8-2 .
•
Set Factory Defaults - Scan this bar code to restore the factory default values listed in Table 8-1 on page 8-2
If custom defaults were set, they are eliminated.
•
Write to Custom Defaults - Scan this bar code to store the current scan engine settings as custom defaults.
Once custom default settings are stored, they can be recovered at any time by scanning Restore Defaults .
* Restore Defaults
Set Factory Defaults
Write to Custom Defaults