Symbol MiniScan MS XX07 Series, Integration Manual

Page: 246 / 406

11-4
MS XX07 Series Integration Guide
RS-232 Host Parameters
Various RS-232 hosts are configured with their own parameter default settings ( Table 11-
2 ). Selecting the ICL, Fujitsu, Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, Olivetti,
Omron, or standard sets the defaults listed below.
Table 11-2. Terminal Specific RS-232
Parameter
Standard
(Default)
ICL Fujitsu
Wincor-
Nixdorf
Mode A
Wincor-
Nixdorf
Mode B/
OPOS
Olivetti Omron
Transmit Code ID No Yes Yes Yes Yes Yes Yes
Data
Transmission
Format
Data as is
Data/
Suffix Data/
Suffix
Data/Suffix Data/Suffix
Prefix/Data/
Suffix
Data/Suffix
Suffix
CR/LF
(7013)
CR (1013) CR (1013) CR (1013) CR (1013) ETX (1003) CR (1013)
Baud Rate 9600 9600 9600 9600 9600 9600 9600
Parity None Even None Odd Odd Even None
Hardware
Handshaking
None
RTS/CTS
Option 3
None
RTS/CTS
Option 3 RTS/CTS
Option 3
None None
Software
Handshaking
None None None None None Ack/Nak None
Serial Response
Time-out
2 Sec. 9.9 Sec. 2 Sec. 9.9 Sec. 9.9 Sec. 9.9 Sec. 9.9 Sec.
Stop Bit Select One One One One One One One
ASCII Format 8-Bit 8-Bit 8-Bit 8-Bit 8-Bit 7-Bit 8-Bit
Beep On <BEL> Disable Disable Disable Disable Disable Disable Disable
RTS Line State Low High Low Low
Low = No
data to send
Low High
Prefix None None None None None STX (1002) None
*In the Nixdorf Mode B, if CTS is Low, scanning is disabled. When CTS is High, the user can scan
bar codes.
**If Nixdorf Mode B is scanned without the scanner connected to the proper host, the scanner may
not be able to scan. If this happens, scan a different RS-232 host type within 5 seconds of cycling
power to the scanner.