Symbol LS 4208, Manual

Page: 91 / 278

Parameter
Stand
ard
ICL Fujits
Winco
r-
Nixdo
rf
Wincor-Nixd
orf
Olivetti Omron
Transmit Code ID No Yes Yes Yes Yes Yes Yes
Data Transmission
Format
Data as
is Data/Su
ffix Data/Su
ffix Data/Suf
fix Data/Suffix Prefix/Data/Su
ffix Data/Suffi
x
Suffix CR/LF
(7013) CR
(1013) CR
(1013) CR
(1013) CR (1013) ETX (1002) CR (1013)
Baud Rate 9600 9600 9600 9600 9600 9600 9600
Parity None Even None Odd Odd Even None
Hardware
None RTS/CT
S
Option None RTS/CTS
Option 3 RTS/CTS
Option 3 None None
Software
Handshaking None None None None None Ack/Nak None
Serial Response
Time-out
2 Sec. 9.9 Sec. 2 Sec. 9.9 Sec. 9.9 Sec. 9.9 Sec. 9.9 Sec.
Stop Bit Select One One One One One One One
ASCII Format 8-Bit 8-Bit 8-Bit 8-Bit 8-Bit 7-Bit 8-Bit
Beep On <BEL> Disable Disable Disable Disable Disable Disable Disable
RTS Line State
Low High Low Low Low = No data
to
send Low High
Prefix None None None None None STX (1003) None
RS-232 Interface 6-5
RS-232 Host Parameters
Various RS-232 hosts are set up with their own parameter default settings ( Table 6-2 ). Selecting the ICL, Fujitsu, Wincor-Nixdorf
Mode
A, Wincor-Nixdorf Mode B, Olivetti, Omron, or terminal sets the defaults listed below.
Table 6-2. Terminal Specific RS-232
*In the Nixdorf Mode B, if CTS is Low, scanning is disabled. When CTS is High, the user can scan bar codes.
**If Nixdorf Mode B is scanned without the scanner connected to the proper host, it may appear unable to scan. If this happens, scan a different RS-232
host type within 5 seconds of cycling power to the scanner.