4.1 Checking the CPU Status
This section describes how to check the CPU status on the system monitoring interface.
Reference Standard
If the CPU is in the
Presence detected
state, it indicates that the CPU is running normally.
Procedure
Step 1
Before login, ensure the IP addresses of the Windows PC and the NetBackup 5200 are in the
same network segment.
Step 2
Open a browser (Internet Explorer 7 or 8 with compatibility mode enabled or Firefox are
recommended) on the Windows PC. Enter
http://IP address
in the address bar (the
IP
address
is the IP address of the service network port of the NetBackup 5200). Press Enter, and
then the
Security Alert
Interface is displayed, as shown in
.
Figure 4-1
Security Alert interface
Step 3
Click
Yes
, the
Log on
interface is displayed, as shown in
4 Guide to the Routine Maintenance Using the System
Monitor Interface
NetBackup 5200
Routine Maintenance
4-2
Symantec Corporation
Issue 01 (2010-08-30)