-9-
1. Push the camera into the locating hole on the battery cover.
2. Open the battery cover with the camera attached.
3. Lock screws to ensure camera unit stays secure.
4. Close the battery cover with camera attached and insert the 3-pin plug into the socket .
Make sure the 3-pin plug of camera is inserted to the quadcopter.
Turn the quadcopter power on, the camera works normally when the
RED
indicator light changes form flashing to
GREEN
and stays on.
If the
RED
indicator just lights up then goes off seconds later, it means there
is no SD Memory card in the camera. Please insert the supplied SD card in,
then the indicator light will turn
GREEN.
Turn on the transmitter and pull left lever up and down to connect signal between
quadcopter and transmitter.
Take Photo:
To take a
PHOTO
push the button near
the throttle lever
UP
. The camera will take a photo after
a beep from transmitter when the
GREEN
indicator
on camera flash one time in
RED.
Take Video:
To take
VIDEO
push the button near the
throttle lever DOWN for a few seconds. The camera
starts taking video when you will hear a beep from the
transmitter and the
GREEN
indicator on camera changes
to
RED
and keeps flashing. Press the button slightly again, another beep means
video stopped and the
RED
flashing indicator on camera will keep light on
GREEN
.
Thanks to the 6 axis gyroscope, you can throw
the quadcopter and push the throttle right up, it
will automatically level out and hover smoothly
in the sky, This can also be done when the
quadcopter is rolling.
1
2
3
4
INSTALL CAMERA
Camera unit is supplied fitted with the X5C Version
PHOTOGRAPHY / VIDEO USE
