4
fig. 9
Step 2: Attach 4 MEDIUM BRACKETS [O] to the bottom of insert with 4 MEDIUM KD
SCREWS [P] as shown in Fig. 10
fig. 10
Step 3: Tighten all SCREWS.
Step 4: Move assembled unit to desired location. Unit should not be positioned in
area exposed to direct sunlight.
WALL ANCHOR SAFETY CABLE
The use of WALL ANCHOR SAFETY CABLE is highly recommended in order to reduce
the risk of the fireplace being tipped over accidentally. WARNING: This CABLE may
reduce possible risk of injury if the fireplace is improperly handled, but is not a
substitute for proper adult supervision. Children should not be left unattended near
any heater.
1. Drill a 5/16” (8mm) hole in the wall. Insert the PLASTIC WALL ANCHOR into the
hole and gently tap until the flange on the anchor is against the wall surface.
2. Position the back edge of the mantle close to the wall.
3. Attach the SAFETY CABLE to the mantel using the SCREW FOR MANTEL.
See figure 11.
fig. 11
4. Use the SCREW FOR WALL to attach the other end of SAFETY CABLE to the wall.
5. Make sure all screws are tight.
OPERATION
After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15AMP/120Volt outlet. If the cord does not reach, you
may use an extension cord rated for a minimum of 1875 WATTS. Once the fireplace in-
sert has been properly connected to a grounded electrical outlet, it is ready to operate.
OPERATION BY THE CONTROL PANEL
ON/OFF: Press this button for main power function. The unit will beep and the indica-
tor light will be on. Pressing again will stop the main power function.
FLAME/LOG: Press this button once for flame effect. The unit will be beep and the
indicator light will be on. The bulbs for flame effect & log-set will be on. Pressing but-
ton again will stop the light function.
750W: Press this button for low heat level. The unit will beep, the pilot light and indi-
cator light will be on. The fireplace heater will give low heat level. Pressing once again
will stop the low heat level function.
1500W: Press this button for high heat level. The unit will beep, the pilot light and
indicator light will be on. The fireplace heater will give high heat level. Pressing once
again will stop the high heat level function.
May not be exactly as shown.