OSRAM and OPTOTRONIC are registered trademarks of OSRAM GmbH.
Specifications subject to change without notice
1-800-LIGHTBULB (1-800-544-4828)
© 2010 OSRAM SYLVANIA Inc. 08/10
1.
Remove the cover of the connection box on the AC side. Insert the AC Line supply cable through one of the access holes
provided -
Use conduit, appropriate for the application and the installation.
2.
Connect the AC Line supply cable to the wires of the power supply. Observe polarity.
3.
Tighten conduit and reinstall the cover.
Apply sealant for water-proof sealing on the conduit and the cover (for outdoor
installations).
4.
Remove the cover of the connection box on the DC side.
Insert the LED module leader cable through one of the
access holes provided
−
Use conduit, appropriate for the application and the installation,
if required.
5.
Connect the LED Leader cable/wires to one set of output
wires (channel) of the power supply. Observe polarity.
−
Repeat steps 4 and 5 for adding output connections. Use the
additional access holes for wire access.
6.
Seal connection holes and reinstall the cover.
−
Appropriate wet-rated grommets may be used to seal the
connection holes (not provided).
−
For outdoor installations: Apply sealant for water-proof sealing
on the conduit(s)/grommet and the cover.
Note:
For outdoor installations, the cable/cord connecting the LED module to the
power supply must be rated and marked W, PLTC, CL3R and “Sun Resistant”.
Gray (+)
Black (-)
Gray (+)
Black (-)
Gray (+)
Black (-)
80W (max)
80W (max)
80W (max)
PRIMARY
(AC) Side
SECONDARY
(DC) Side
Black (L)
White (N)
Green (GND)
INPUT
Line AC
120-240V AC
OUTPUT
24V DC
3 x 80W
Wiring Instructions – Primary Side:
AC INPUT: 120-240V AC
L - Black
N – White
GND – Green/Yellow
AC Wires/Cable
Wire Nuts
Water-tight
sealant
Wiring Instructions – Secondary Side:
Note:
Refer to the respected LED module Product Information Bulletin and Installation Guide to verify compatibility and particular electrical
requirements and limitations that may apply.
1
2
3
Water-tight
sealant
Wire Nuts
DC OUTPUT: 3x 24V DC
Class II
+24V – Gray
GRN – Black
MAX: 80W/chnl
4
5
6
Note:
The OT240W/3X24V/120-240V/JBX has three independent 24V
output channels, each rated for a maximum LED load of 80W.
Optional Wet
rated grommet
(Not-provided)