4
O/I:
Press this button for main power. The indicator light will turn on.
: Standby switch. Press this switch once the unit become energized and you
can select the following functions as desired. Press this switch again. The unit will
be OFF and enter standby mode.
:
Press this button once for flame effect. The unit will be beep and the indica-
tor light will be ON. The bulbs for flame effect & log-set will be ON. To adjust the
flame intensity, hold down the button - the flame optics will go higher or lower.
Once you have found the desired setting, release the button. Pressing the button
again will stop the light function.
750 W:
Press this button the low heat level. The unit will beep and the indicator light
will be ON. The fireplace heater will give off low heat. Pressing once again will
stop the low heat level function.
1500 W :
Press this button the high heat level. The unit will beep and the indicator
light will be ON. The fireplace heater will give off high heat. Pressing once again
will stop the high heat level function.
Heat Temperature Control Knob:
To adjust the temperature to your individual
requirements, turn the temperature control dial to the right (clockwise) to increase
the desired temperature and to the left (counter clockwise) for lower temperature.
Note:
When the
O/I
switch is turned off, all other heater functions will stop even
though the switches may be in the ON position.
MaiNtENaNcE WarNiNG:
Disconnect power and unplug the power cord before attempting any maintenance or
cleaning to reduce the risk of fire, electric shock or damage to persons. The bulbs in
your unit can become extremely hot. Allow at least 10 minutes between turning off
the unit and removing the light bulbs to avoid the accidental burning of the skin.
riSK OF FirE: DO NOt ExcEED tHE rEcOMMENDED BUlB WattaGE.
OPERATION BY THE REMOTE CONTROL
Plug in your electric fireplace and it will beep once, this means you have power and
your remote is ready to operate your electric fireplace.
: Standby switch. Press this switch once the unit become energized and you can
select the following functions as desired. Press this switch again. The unit will be
OFF and enter standby mode.
:
Press this button once for flame effect. The unit will be beep and the indicator
light will be ON. The bulbs for flame effect & log-set will be ON. To adjust the flame
intensity, hold down the button - the flame optics will go higher or lower. Once you
have found the desired setting, release the button. Pressing the button again will
stop the light function.
750W:
Press this button for low heat level. The unit will beep, the pilot light and
indicator light will be on. The fireplace heater will give low heat level. Pressing once
again will stop the low heat level function.
1500W:
Press this button for high heat level. The unit will beep, the pilot light and
indicator light will be on. The fireplace heater will give high heat level. Pressing once
again will stop the high heat level function.
REMOTE CONTROL BATTERY REPLACEMENT
Replace with 2 AAA batteries.