4
fig. G
Step 8: Attach fireplace insert to the unit as shown in Fig. H, with 6 medium KD screws
[U]. [ 4 screws at the top of insert and 2 screws at the large ‘L‘ brackets ]
fig. H
Step 9: Tighten all screws.
Step 10: Carefully move the assembled unit to the desired location. The fireplace
mantel should not be positioned in an area exposed to direct sunlight.
WALL ANCHOR SAFETY CABLE
The use of the wall anchor safety cable is highly recommended in order to reduce the
risk of the fireplace being tipped over accidentally. WARNING: This cable may reduce
possible risk of injury if the fireplace is improperly handled, but is not a substitute for
proper adult supervision. Children should not be left unattended near any heater.
1. Drill a 5/16 in (8 mm) hole in the wall. Insert the plastic wall anchor into the hole
and gently tap until the flange on the anchor is against the wall surface.
2. Position the back edge of the mantle close to the wall.
3. Attach the safety cable to the mantle using the screw for mantel.
4. Use the screw for wall to attach the other end of the safety cable to the wall.
5. Make sure all screws are tight.
WALL
OPERATION
After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15 AMP/120 Volt outlet. If the cord does not reach,
you may use an extension cord rated for a minimum of 1875 WATTS. Once the
fireplace insert has been properly connected to a grounded electrical outlet, it is ready
to operate.
OPERATION BY THE CONTROL PANEL
ON/OFF:
Press this button for main power function. The unit will beep and the indica-
tor light will be on. Pressing again will stop the main power function.
FLAME/LOG:
Press this button once for flame effect. The unit will be beep and the
indicator light will be ON. The bulbs for flame effect and log-set will be ON. To adjust
the flame intensity, hold down the button - the flame optics will go higher or lower.
Once you have found the desired setting, release the button. Pressing the button
again will stop the light function.
750 W:
Press this button for low heat level. The unit will beep, the pilot light and
indicator light will be ON. The fireplace heater will give low heat level. Pressing once
again will stop the low heat level function.
1500 W:
Press this button for high heat level. The unit will beep, the pilot light and
indicator light will be on. The fireplace heater will give high heat level. Pressing once
again will stop the high heat level function.
HEAT TEMPERATURE CONTROL KNOB:
To adjust the temperature to your individual
requirements, turn the temperature control dial to the right (clockwise) to increase the
desired temperature and to the left (counter clockwise) to lower the temperature.
