6.3 Operating conditions
Do not expose the product to any mechanical stress.
Protect the product from extreme temperatures, strong jolts, flammable gases, vapours,
and solvents.
Protect the product from high humidity and moisture.
The product must not be exposed to direct sunlight.
Do not operate the product when covered.
Never use the product immediately after it has been taken from a cold room into a warm
one. The condensation that forms may cause an electric shock or destroy the product..
Allow the product to reach room temperature before using it.
6.4 Operation
Consult an expert when in doubt about the operation, safety or connection of the device.
Never pour liquids over electrical devices or place objects filled with liquid next to the
device. If liquid or an object does get inside the device, power down the respective socket
(e.g. switch off the circuit breaker), and then remove the mains plug from the mains socket.
If the product shows signs of damage, do not touch it, as there is a risk of death from an
electric shock! First, switch off the mains voltage to the mains socket to which the product
is connected (switch off the respective circuit breaker or remove the safety fuse, and then
switch off the respective GFCI so that the mains socket is fully disconnected). You can then
unplug the product from the mains socket. Do not use the product again.
If it is no longer possible to operate the product safely, stop using it and prevent
unauthorised use. DO NOT attempt to repair the product yourself. Safe operation can no
longer be guaranteed if the product:
– is visibly damaged,
– is no longer working properly,
– has been stored for extended periods in poor ambient conditions or
– has been subjected to any serious transport-related stress.
6.5 Power cable
Never attempt to modify the components of the product. Risk of fatal electric
shock!
Always ensure that the mains plug is properly connected.
Discontinue use of the device if any electrical components are damaged.
Do not modify the electrical components.
The mains socket must be located near to the product and be easily accessible.
Never plug in or unplug the mains plug when your hands are wet.
Never pull the mains cable to disconnect the device from the mains socket. Always pull it
from the mains socket using the intended grips.
Unplug the mains plug from the mains socket if you do not plan to use the product for an
extended period of time.
For safety reasons, always disconnect the mains plug from the mains socket during
thunderstorms.
Make sure that the mains cable is not squeezed, bent, damaged by sharp edges or
subjected to mechanical stress.
Avoid excessive thermal stress on the mains cable from extreme heat or cold.
Do not attempt to modify the product, as this may damage the product or the mains cable.
A damaged mains cable can cause a fatal electric shock.
Do not touch the mains cable if it is damaged.
– First, power down the respective mains socket (e.g. via the respective circuit breaker),
and then carefully pull the mains plug from the mains socket.
– Never use the product if the mains cable is damaged.
A damaged mains cable may only be replaced by the manufacturer, a workshop
commissioned by the manufacturer, or a similarly qualified person so as to prevent any
danger.
Always lay cables so that nobody can trip over or become entangled in them. Risk of injury!
6.6 Connected devices
Also observe the safety and operating instructions of any other devices that are connected
to this product, in particular the specifications on voltage limits and current consumption.
Operating instructions
Power strip
Item no. 2490493 / 3 sockets
Item no. 2490616 / 6 sockets
1 Intended use
This product can be used as a power strip or as an extension cable to power several connected
devices.
The product is intended for indoor use only. Do not use it outdoors. Contact with moisture must
be avoided under all circumstances.
Using the product for purposes other than those described above may damage the product.
Improper product use can cause a short circuit, fire, electric shock
or other hazards.
This product complies with statutory, national and European regulations. For safety and
approval purposes, you must not rebuild and/or modify the product.
Read the operating instructions carefully and store them in a safe place. Make this product
available to third parties only together with the operating instructions.
All company and product names contained herein are trademarks of their respective owners.
All rights reserved.
2 Delivery content
Power strip
Operating instructions
3 Latest product information
Download the latest product information at
www.conrad.com/downloads
or scan the QR code
shown. Follow the instructions on the website.
4 Symbols in this document
The symbol warns of hazards that can lead to personal injury.
The symbol warns of dangerous voltage that can lead to personal injury by electric
shock.
5 Symbols on the product
Read the operating instructions carefully before use..
This product must only be used in dry, enclosed indoor areas. It must not get damp
or wet.
6 Safety information
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information on
proper handling, we assume no liability for any resulting personal injury or
damage to property. Such cases will invalidate the warranty/guarantee.
6.1 General information
This product is not a toy. Keep it out of the reach of children and pets.
Maintenance, modifications and repairs must be carried out by a technician or a specialist
repair centre.
Should you have any questions or concerns after reading this document, please contact
our technical support or a professional technician.
6.2 Handling
Please handle the product carefully. Impact, shocks or a fall even from a low height can
damage the product.
Do not use the product if there are visible signs of damage.
Only connect the product to intact and undamaged grounded sockets.
Do not connect several power strips in series.
Do not use the product if it has come into contact with moisture or liquids, and do not use
the product with wet hands.
