7.
Save the file and close it.
8. Eject the storage drive and disconnect the product from the computer.
9. Turn the product off and on again to load the new settings.
Setting
Description
YYYY/MM/DD hh:mm:ss
Set date and current time
Note:
After restarting the product, the date and time in < time.txt > is reset to
‘2019/01/01 00:00:00’. However, the product uses the time you set.
1080P or 720P
Video recording quality
1 or 0
1 = overwrite storage when full (loop recording)
0 = do not overwrite storage when full (stop recording)
Recording
The product can take pictures and record videos. Videos are recorded continuously or by motion detection.
Low light recording is activated automatically when light levels fall below a preset threshold.
a) About low light recording
Activation:
Night vision recording distance:
<15 lux
max. 5 m
Low light recording is activated automatically when light levels fall below the preset threshold. The recorded
video will be in black and white.
b) Selecting recording modes
Below table lists the available modes and corresponding indicator light colours in standby mode.
Mode
Indicator lights (in standby)
Picture
Both red
Video
One red, one blue
Video with motion detection
Both blue
1. Turn the product on.
2. Press the mode selection button
(10)
until the indicator lights
(11)
indicate the desired mode.
c)
Taking pictures
1. Turn the product on and select the picture mode.
2. Press the power button
(1)
to take a picture. Both indicator lights blink briefly and the picture is saved.
d)
Recording video
Recording time: 3 minutes per video (segment)
1. Turn the product on and select the video mode.
2. Press the power button
(1)
to start recording. The red indicator light flashes and both lights go out after
a short time.
3. Video segments are recorded and saved continuously until:
- you switch the product off; you connect it to a computer; the battery is depleted;
-
storage is full (you decided to not overwrite the storage in the settings)
•
To stop recording, hold the power button for 3 seconds. The indicator lights briefly light up.
e)
Recording video through motion detection
Recording time:
Detection distance:
Detection angle:
1 minute per video (segment)
max. 5 m
45° (horizontal and vertical)
Activating motion detection
1. Turn the product on and select the video mode with motion detection.
2. Press the power button
(1)
to start recording. The red indicator light flashes and both lights go out after
a short time.
3. The product will now record when motion is detected.
4. Video segments are recorded and saved continuously until:
- you switch the product off; you connect it to a computer; the battery is depleted;
-
storage is full (you decided to not overwrite the storage in the settings)
•
To stop recording, hold the power button for 3 seconds. The indicator lights briefly light up.
Managing saved recordings
You can play back and manage recorded data through a card reader or by directly connecting the product
to your computer.
Using a card reader
1. Turn the product off.
2. Remove the microSD card and insert it into a suitable card reader.
3.
Connect the card reader to an available USB port on your computer.
4. Wait for the storage drive to show up.
Connecting the product to the computer
1.
Connect the product to your computer using a
USB data cable.
2. Turn the product on.
3. Wait for the storage drive to show up.
Managing recordings
•
Pictures are accessible from the < IMAGE > folder.
•
Videos are accessible from the < VIDEO > folder.
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights in
-
cluding translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication
represents the technical status at the time of printing.
Copyright 2020 by Conrad Electronic SE.
*2203065_v2_0420_02_jh_m_4L_(2)
Camera Stand
The camera stand features a magnetic base onto which you place the magnetic base of the camera. The
leg of the stand is adjustable.
Installing the stand permanently
The adhesive base may leave marks or damage sensitive surfaces. Do not adhere the stand
to a vertical or inverted (upside down) surface. There is a risk that the camera may fall causing
damage or injury.
• Remove the adhesive backing from the stand foot and attach to a suitable surface.
- For maximum adhesion, make sure the contact area is smooth, dry and free from debris.
• When making adjustments to the stand, always hold the base of the stand against the surface to prevent
the adhesive from peeling off.
Troubleshooting
a)
Resetting the product
In case the product does not respond or behaves in unexpected ways, resetting may resolve the problem.
1.
Gently insert a mobile phone SIM pin or similar tool (like a paperclip) into the reset button opening
(8)
and push the reset button once.
2. The product will return to factory default settings.
b) Product does not record video
•
Is an microSD card installed?
•
Check the recording settings in the configuration file.
•
Are there any mistyped configurations in the configuration file?
Care and Cleaning
• Disconnect the product from the USB cable before cleaning.
• Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solutions as they can
cause damage to the housing and malfunctioning.
•
Clean the product with a dry, fibre-free cloth.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the household waste.
At the end of its service life, dispose of the product in accordance with applicable regulatory
guidelines. You thus fulfill your statutory obligations and contribute to the protection of the envi
-
ronment.
Technical Data
a) Power
Input voltage / current
...........................
5 V/DC, 500 mA via micro USB
Rechargeable battery ...........................
LiPo, 3.7 V, 1000 mAh
Battery recharge time ........................... approx. 4.5 hours
Runtime ................................................
approx. 6 hr (day light), approx. 3 hr (low light)
b) Camera
Motion detection ...................................
45º detection angle,
5 m detection distance
Low light recording
............................... < 10 lux to activate, max. 5 m distance
c) Storage
Memory type .........................................
microSD, 8 – 32 GB (class 4 to 10)
Formatting ............................................ FAT32
d) Pictures
Viewing angle ....................................... horizontal : 38º, vertical: 30°
Format .................................................. JPEG
Dimensions ........................................... 4032 x 3024 px
Size ....................................................... approx. 1.4 MB
e) Video
Viewing angle ....................................... horizontal : 50º, vertical: 30°
Audio .................................................... mono
Format ..................................................
AVI (M-JPEG coding)
Resolution .............................................
720P (1280 x 720 px , 30 fps)
1080P (1920 x 1080 px, interpolated, 30 fps)
Segments .............................................
3 min. / file (normal), 1 min. / file (motion detection mode)
f) Other
Operating / storage conditions ..............
0 to +50 ºC, 0 – 85 % RH
Dimensions (H x W x D)
.......................
33 x 33 x 35 mm (without stand), 70 x 33 x 35 mm (with stand)
Weight ..................................................
Camera: 38 g, Stand: 16 g
