Sybase 12.5.1, User Manual

Page: 47 / 210

User’s Guide
33
C H A P T E R 3
Starting and Stopping Historical
Server
Starting and stopping Historical Server on UNIX
platforms
This section describes how to start and stop Historical Server running on
UNIX platforms.
Starting Historical Server on UNIX
On UNIX, you can start a configured Historical Server in two ways:
• Execute the
histserver
command from a UNIX shell prompt. If you
use this method, you must type all appropriate parameters each time.
• Execute a script file that contains the
histserver
command and all
appropriate parameters. If you followed the configuration
instructions in Chapter 2, “Configuring Historical Server,” you
would start Historical Server using:
install_dir /install/RUN_ histServerName
where install_dir is the Sybase root directory and histServerName is
the name of the Historical Server you want to start.
Regardless of which method you use:
• Verify that the Adaptive Server to be monitored and its corresponding
Monitor Server are running.
Topics Page
Starting and stopping Historical Server on UNIX platforms 33
Starting and stopping Historical Server on Windows NT 36