V1.0
5
System Connection
Figure 1 - HDBT-131EC System Configuration Example
Connection Procedure
The following steps are the connections required for any installation:
1.
Connect the HDMI source to the HDMI input port of the SY-HDBT-131EC using a good quality
HDMI cable.
2.
Connect the cat5e/6/6a cables between the SY-HDBT-131EC and HDBaseT receivers via good
quality RJ45 cat5e/6/6a cable. This cable must connect directly between the SY-HDBT-131EC and
the respective HDBaseT receiver.
3.
Connect a display device to the HDMI output port on each of the SY-HDBT-131EC HDBaseT
receivers using an HDMI cable.
4.
Connect a display device to the local HDMI output port on the using an HDMI cable.
5.
Connect the 24V DC power supply adapter and tighten to secure. For the MUBT-44/88EC an IEC
mains cable is connected directly to the HDBaseT splitter. Once all components have been
connected and the installation is completed, switch on the supply.
Notes: When using IR receivers connected to IR IN, the IR carrier must be present. Do not use IR detectors
that remove the IR carrier signal.
