3
( )
This completes the interconnection of the disk and the computer. The disk
unit is now ready for checkout/
Checkout and Use
( )
Be sure that your computer contains enough memory to run the disk operating
system that you are using. The software manual supplied with the diskette
should specify the amount of memory required.
( )
After connecting the disk unit is ready for use. If at any time the disk
fails to operate as described, power down the system and recheck all
assembly.
( )
Power up the disk unit and computer. The power switch for the disk unit is on
the back panel. The switch is ON when the paddle on the switch is toward the
right as viewed from the front.
( )
Write protect the system diskette by placing a small piece of tape around the
square notch on the side of the diskette.
( )
This completes the interconnection of the disk and the computer. The disk
unit is now ready for checkout.