_____________________________________________________________________________________
SWS – 7695 Blackburn Parkway, Niagara Falls, ON Canada
Tel: 1-877-357-0222 | Fax: 905-357-9122 | [email protected]
300402 Rev. 2X
Page
1
of
5
75035 Snow Plow Array Instructions
The following is a list of recommended practices for the
installation and operation of your light.
FAILURE TO FOLLOW THESE SAFETY PRECAUTIONS AND INSTRUCTIONS COULD RESULT IN
DAMAGE TO THE PRODUCT OR VEHICLE AND/OR SERIOUS INJURY AND/OR DEATH TO YOU AND
YOUR PASSENGERS
•
Proper installation of this product requires the installer to have a good understanding of automotive
electronics, systems and procedures. You may need to consult a professional for installation.
•
SWS Warning Systems Inc. recommends the use of waterproof butt splices and/or connectors for all
electrical connections. It is recommended that the use of good dielectric grease be used on all
connections where possible.
•
SWS Warning Systems Inc. does not recommend leaving a magnetically mounted light on a vehicle
while the vehicle is in motion. The owner does so at their own risk.
•
If mounting this product requires drilling holes, the installer MUST be sure that no vehicle components
or other vital parts could be damaged by the drilling process. Also de-burr the holes and remove any
metal shards or remnants. Grommets are recommended for all wire holes.
•
Do not mount the light close to antennae or radio equipment, as they may cause electromagnetic
interference. After installation of the light, it is necessary to test all electronic equipment
simultaneously to ensure that they operate free of interference from other components within the
vehicle.
•
Never power emergency warning equipment from the same circuit or share the same grounding
circuit with radio communication equipment.
•
Do not install this product or route any wires in the deployment area of your air bag or areas that
interfere with the operation of the vehicle. Refer to your vehicle owner’s manual for the air bag
deployment area and recommended mounting areas for warning lights and other equipment.
•
Do not attempt to activate or control the device with the vehicle in motion or in a hazardous driving
environment. The vehicle should be stopped and in park before control of the light is attempted.
•
Do not stare directly into these lights. Momentary blindness and/or eye damage could result.
•
Use only soap and water to clean the product. Use of other chemicals could result in degradation and
discolouration of the lens/dome.
•
Do not use a pressure washer to clean this product.
•
Inspect and operate this product regularly to confirm its proper operation and mounting condition.
•
It is recommended that these instructions be stored in a safe place and referred to when performing
maintenance and/or reinstallation of this product.
•
SWS Warning Systems Inc. and its subsidiaries are not responsible for any damages due to
improperly mounted or improperly wired lighting equipment.
