background image

POWER 750

LIMITED WARRANTY

The 

POWER 750 

from SWR is warranted to the original consumer purchaser for TWO YEARS

from the date of purchase against defects in materials and workmanship, provided that it is pur-
chased from an Authorized SWR dealer.  This warranty applies only to products purchased in the
USA or Canada.

This warranty is VOID if the unit has been damaged due to accident, improper handling, installa-
tion or operation, shipping damage, abuse or misuse, unauthorized repair or attempted repair, or if
the serial number has been defaced or removed. FMIC reser ves the right to make such determi-
nation on the basis of inspection by an Authorized FMIC Ser vice Center.

All liability for any incidental or consequential damages for breach of any expressed or implied
warranties is disclaimed and excluded herefrom.

Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or
limitation of incidental or consequential damages, so that the above exclusion may not apply to
you. This warranty gives you specific legal rights and you may also have other rights which var y
from state to state.

For a complete list of Authorized FMIC
Service Centers, and the latest SWR
news, interviews, and more, check out
our website:

SWR

8860 E Chaparral Rd, Suite 100

Scottsdale, AZ 85250-2618 USA

PHONE: 

(480) 596-9690

FAX:

(480) 367-5262 

EMAIL:

custser [email protected]

WEB:

swrsound.com

swrsound.com

POWER 750 OWNER’S MANUAL • Part # 0066564000 • 12/03

Copyright © 2003 SWR

SHOULD YOUR SWR AMPLIFIER REQUIRE SERVICE OR REPAIR, PLEASE USE THE
FOLLOWING PROCEDURE:

Locate your original receipt showing date of purchase, model and serial number.

Determine the closest Authorized FMIC Service Center to your location.  The fastest way to get a complete list of Authorized FMIC Service
Centers is on the web at:

http://www.mrgearhead.com/faq/allservice.html

You can also get this information by calling FMIC Consumer Relations at (480) 596-7195

To receive warranty service, return the complete product to an Authorized FMIC Electronics Service Center, with proof of purchase, during
the applicable warranty period.  Transportation costs are not included in this Limited Warranty.

Defective products that qualify for coverage  under this warranty will be repaired or replaced, at FMIC’s discretion, with a like or comparable
product, without charge.

1

2

3

4

Summary of Contents for Amplifier POWER 750













Reviews: