10
Page
Version 1.0 May 2017
X5 – Grove Moisture Sensor – Identical to the two Moisture Sensors included in SmartPlantPl.
Assembly
Step 1) Power off your SmartPlantPi system
Step 2) Connect a 50cm Grove cable (or shorter if desired) to a Grove Moisture Sensor (Part X5). Note: This is identical
to the Grove Moisture Sensors shipped with SmartPlantPi.
Step 3) Plug the other end of the 50cm Grove cable into the OUT Grove Connector on the Grove PowerSave (Part X4)
Step 4) Plug a Grove cable into the CONTROL Grove Connector on the Grove PowerSave (Part X4)
Step 5) Plug the other end of the Grove Cable in Step 4) into the D6/D12 Connector on the Pi2Grover board
