35
Page
Version 1.1 December 2020
Step 3: Place the SkyWeather2 Top (Part C) on top of the Base (Part B) with the tab on the right side of the
Base Unit (Part B). Again, if you reverse it the camera orientation can be fixed in software.
Step 4: Take the four M3 20mm screws and screw or push them so they just come out the bottom of the Top
(Part C). Align these with the Brass Inserts in the SkyWeather Base Unit (Part B) and get each one of them to
bite into the inserts. This can be a little tricky. Tighten each one a few turns before moving around in a
clockwise manner. Like tightening the lug nuts on a tire.
