Wiring at the installation location (mains supply)
1
Slip the other end of the pendant cable into the profile and fix the wire with
the pendant cable by a cable clip
Fasten the pendant cable on the profile and fix the pendant rope with the strip
wire by the protective sleeve
7
8
Install the power supply at a proper location
2
Do not touch with wet hand or there is risk of electric shock
4 Fix one end of the pendant cable on the rubber plug or plate
4
Make an opening of
φ
5mm at the mounting position and seal it with a rubber
plug
3
Do not place the power supply in water or remove it without permission
The number of pendant cables to be used depends on the profile length (L):
If the product is mounted on a plate, skip the step
Place insulation on both ends of the strip and place the strip on the profile
5
Mount the diffuser on the profile (K, C or P diffuser to be selected depending
on the application demand)
6
Strips with exposed copper foil on the back shall be insulated
LED-
LED+
DIM-
DIM+
Driver
GND
AC-N
AC-L
Connect to DIM
·When L
≤
1.2m, 2pcs of pendant cables are recommended
·When 1.2m
＜
L
≤
2.5m, 4pcs of pendant cables are recommended
w w w . s w i t c h - m a d e . c o m
SWITCH
MADE
USER
MANUAL
