w w w . s w i t c h - m a d e . c o m
SWITCH
MADE
USER
MANUAL
Trunk Light
Connecting Trunking Rail
Mounting Suspension
Drill a hole on ceiling
Both trunking rails should keep in perfect
position then push to click
2 options: Motion Sensor
Daylight Sensor
Connecting Power Supply
Mounting Luminaire
Mounting Sensor Module
Mounting Track Spot Module
Track spot light
How to dispatch the connected trunking
rails In case of misoperation
To separate both trunking rails screw off the
rail connecting screws then pull apart
Dial switch to set sensor index
For details, please refer to sensor setting
data sheet
Select phase for track spot light
Cut the Rubber cap to pass the power cable
Screw in the conduit gland
Push the sliding lock to lock the luminaire
to trunking rail
Plug in track spot light and lock
Click in and connect cable to corresponding
cable connector
Put in conduit with cable inside and pull
up conduit gland to lock
Connect wires according labeling on
wires to feed in connector then connect
to connector in trunking rail
Adjust length of suspension cord:
a. press down Hexagon bolt;
b. Pull in/out cord to adjust length
Click in mounting clip into trunking rail
Select phase to control corresponding
dimming lights L1/L2/L3
Rotate the knob to horizontal direction
and press down to lock
Fix mounting hook into ceiling
Twist sensor head to adjust angle
Slide knob to select phase L1/L2/L3
Cover with protection cap
Make sure male & female connectors
in right position then fix the luminaire
to trunking rail
Step 4c
Step 4b
Step 4a
Step 3
Step 2
Step 1
NOT_LINEMAX
