Wiring at the installation location (mains supply)
1
Connect the strip wire in the profile with the output line of the power supply,
Fix the profile on the clips
7
8
Install the power supply at a proper location
2
Do not touch with wet hand or there is risk of electric shock
Place insulation on both ends of the strip and place the strip on the profile
3
Mount the diffuser on the profile ( C or K diffuser to be selected depending
on the application demand)
4
Mount the end caps (with and without hole)
5
Make an hole of
φ
5mm at the mounting position and seal it with a rubber
plug, Fixe the clips on the rubber plug or plate
6
Do not place the power supply in water or remove it
without permission
LED-
LED+
DIM-
DIM+
Driver
GND
AC-N
AC-L
Connect to DIM
End cap
End cap with hole
LED-
LED+
DIM-
DIM+
Driver
GND
AC-N
AC-L
Connect to DIM
-
+
LED
Strips with exposed copper foil on the back shall be insulated
For an end cap without hole, wire goes out from the profile bottom,
while it goes out from an end cap with an hole of
φ
4.5mm
LINE G1616C/LINE G1616K plug for the tight structure,
no plug screws
The number of clips to be used depends on the profile length (L):
·When L
≤
1.2m, 2pcs of clips are recommended
·When 1.2m
<
L
≤
2.5m, 4pcs of clips are recommended
Completed
When smoke or the smell of burning is found from the fixture,
please immediately turn it off
w w w . s w i t c h - m a d e . c o m
SWITCH
MADE
USER
MANUAL