4
Aton CL114 / Swisscom EN / A31008-M2402-F151-1-2X19 / Bali.fm / 13.07.2012
Te
mpla
te Bali, V
e
rsion
1, 16.0
2.2012
Initial charging and discharging of the batteries
The correct charge status can only be displayed if the batteries are first fully charged and discharged.
Changing the display language
Change the display language if you do not understand the language currently set:
§Menu§
¤
421
(press the keys one after the other)
¤
q
(select language)
¤
§OK§
(
‰
=
current language)
¤
Press and hold the end call key
a
to return to idle status.
Setting the date and time
Set the date and time so that the correct date and time can be assigned to incoming calls, and so that the alarm can be
used.
§Menu§
¤
q
Settings
¤
§OK§
¤
Date/Time
¤
§OK§
¤
Date
¤
~
(enter the day, month and year in 6-digit format)
¤
§OK§
¤
Time
¤
~
(enter hours and minutes in 4-digit format)
¤
§OK§
(display message:
Saved
)
¤
a
(press and hold to return to idle status).
You can move the position of an entry to the left or right by pressing the control key left or right
r
.
Please note
◆
Base station and handset package:
The handset is pre-registered with the base station. If you have purchased
a
model with multiple handsets
, all handsets will already be registered with the base station. You do not need
to register the handset again.
However, if a handset is not registered with the base station (
Register HS
or
Put into base
is displayed), please
register the handset manually (
Handset and charging cradle package:
please register the handset manually (
◆
After the first battery charge
and
discharge, you may place your handset in the charger after every call.
◆
Always repeat the charging and discharging procedure if you remove the batteries from the handset and rein-
sert them.
◆
The batteries may warm up during charging. This is not dangerous.
◆
After a while, the charge capacity of the batteries will decrease for technical reasons.
Please note
If your phone receives the date and time during calling line display (e.g., via your network provider, a router or
PABXs), you can specify whether this data should be copied to your phone:
¤
Press the key sequence:
§Menu§
¤
P#Q5#MI
The following is displayed; the current setting flashes:
¤
Press one of the following keys to specify, when this data should be copied to your
phone:
Q
Never
or
1
Once
, in case the date/time is not set on your phone
or
2
Always
Your selection is displayed (e.g.,
2
):
¤
Press the display key
§OK§
.
6 h
¤
Charge the handset in the base station/charging cradle
for
6 hours
.
¤
After charging, remove the handset from the base sta-
tion/charging cradle and only replace it when the batter-
ies are
fully discharged
.
Please note
The handset must only be placed in the designated base
station or charging cradle.
973 SET : [0]
973 SET: [2]