Be sure the blade is not in contact with the work when the motor is started. Start the motor, allow
the saw to come to full speed, then begin the cut by letting the head down slowly onto the work.
DO NOT DROP OR FORCE. Let the weight of the saw head provide the cutting force. The saw
automatically shuts off at the end of the cut.
CHANGING BLADE
Raise saw head to the highest position and open the blade guards. Loosen tension screw knob
sufficiently to allow the saw blade to slip off the wheels. Install the new blade with teeth slanting
toward the motor as follows:
(1). Place new blade and make sure the teeth are pointing the cutting direction.
(2). Turn the blade tension knob clockwise until the proper blade tension is achieved.
(3). Install the blade guards.
(4). Place 2-3 drops of lightweight oil on the blade.
TRU- LOCK VISE SYSTEM INSTRUCTIONS
(a)
(b)
(1) (2) (3)
(1) The position of the vise when tightened.
(2) The position of the vise when loosened. (Half opened)
(3) The position of the vise when loosened. (Completely opened)
To operate, proceed as follows:
1)
Rise the arm about 50mm above the workpiece, close the cylinder valve to maintain the arm
above the workpiece.
2)
Put your workpiece on the table. Move the vise handle (a) upwards to an angle of 45 degree
(a-Half opened) to loosen the vise.
Move the vise jaw bracket against the workpiece by turning the rectangular handle (b). Push
down on the vise handle (a) to lock the workpiece in position.
3)
To loosen the workpiece from the vise, hold the workpiece and lift the vise handle (a) to a 90
degree position (completely opened). Remove workpiece.
QUICK VISE ADJUSTMENT FOR ANGLE CUT
(1). Loosen the A. B. C. D. Screws.
(2). Adjust rear vise to the threaded hole position (E).
(3). Set the scale to the desired angle.
11
