Swisher ZT2350, Owner'S Manual, Page: 11 / 28

SERVICE / ADJUSTMENTS
TRACKING
Adjustments to the unit may need to be made if the unit does not track in a straight line. The
primary reason for the unit not tracking straight is incorrect or unbalanced tire pressure.
Before making any adjustments first check and adjust the tire pressure. DO NOT EXCEED
MAXIMUM RECOMMENDED TIRE PRESSURE.
ADJUST LINKAGE:
Place steering levers outward locking them in the neutral position.
Turn off engine and raise seat. Under the seat are (4) adjustment bolts. The two adjustment
bolts toward the seat mount are adjustments for the forward travel. The two bolts toward the
engine are for the reverse travel. Clockwise movement for these will decrease or slow the
travel speed of the individual side. Counterclockwise movement will increase the travel of the
individual side. The linkage is factory set to maximum performance. Adjustment is made by
rotating the adjustment bolt clockwise on the opposite side that the unit tracks toward. Adjust
forward and reverse to track straight as needed. When accomplished adjustment to the
steering levers may need to be done. This is made by loosening the the two bolts on the
steering lever and aligning with the other. Travel of the steering levers from front to rear may
be accomplished in the same manner.
CAUTION:
Before performing any service or adjustments do as follows:
1. Turn off PTO switch.
2. Position unit on smooth flat surface.
3. Place steering levers in outward, neutral-locked position.
4. Turn ignition key “OFF” and set parking brake.
5. Wait for all moving parts to stop and disconnect spark plug wire.
Neutral-Lock Position
Steering levers out.
Decrease Speed
Increase Speed
Adjustment bolts
Both sides Front of
Mower
Tracking Adjustment
Diagram
11