ADJUSTING THE DRIVE CONTROLS
Remove left and right instrument covers for access
Once the tracking adjustments have been made on
the previous page, the handles can now adjusted
straight across from each other by loosening both
nuts that mount handles and rotate them forward or
backwards.This adjustment can also be used to bring
both handles closer or farther forward for the
comfort of the operator.
The bolt that joins the handle mount to the pivot
weldment has a nylon bushing that provides friction
to control the effort needed to move the control arms
in or out. The proper adjustment is achieved when
arms stay put in any position and a slight effort is
required to reposition them.
Adjusting this screw and its
locking nut can move the
handles left or right to avoid
contact between them.
ADJUSTMENT OF STEERING PIVOT PLATE
View by removing right side instrument cover
This turnbuckle should be adjusted to
position the front of the pivot plate
slightly lower than the rear. Make sure
the handle is out in its neutral position
while making the adjustment.
When replacing this ball linkage
assembly, a sequence needs to be
followed. Put the control handle out in
the neutral position. Fasten the top end
first. Then since the control lever on the
front of the hydro unit self-centers,
lengthen or shorten the ball linkage
assembly until the lower stud falls freely
into the hole on the control.
ADJUSTMENT OF STEERING
View by removing right side instrument cover
11