6
ENGAGING BLADES
Note: Do not attempt to start the unit with the engage switch console in the ‘’ ENGAGED ’’ position.
• Engage blades by pulling out on the PTO switch.
• Push PTO switch in to disengage blades.
See detail on page 16 figure – 8
•The braking system is applied when the blades become disengaged. It is designed to bring the blades
to a quick stop ( approximately 7 seconds. ) The electric clutch comes with an internal brake.
BREAKING IN YOUR CUTTER
•
Set the vehicle parking brake and chock the wheels to prevent accidental rolling.
•
While the engine is running, engage blade control.
•
In a safe environment, (i.e. no children or pets) allow blades to rotate and engine to
idle for 5 minutes, breaking in the belt for a longer life.
•
Stop cutter.
CAUTION: SHUT OFF THE CUTTER ENGINE AND REMOVE SPARK
PLUG WIRE FROM SPARK PLUG BEFORE MAKING ANY
ADJUSTMENTS TO THE CUTTER.
STARTING THE ENGINE
See engine manufacturer’s recommendations for the type and amount of oil and fuel used.
•
Make sure the tow vehicle parking brake is set, mower is level, and blades are
disengaged. Engine must be level to accurately check and fill oil. Do not overfill.
•
Check spark plug wire, oil, and fuel.
•
Check all electrical connections for build-up of debris.
•
Set engine idle to “CHOKE” position.
•
(12V models only) Turn key to the “RUN” position, then to the “START” position.
•
Set engine idle at maximum RPM for best performance.
•
Allow engine to run a few moments before engaging blades.
