Fig. 16: Brake line in upper pulley
Then make a loose knot in the brake line at the mark (behind the pulley, see Fig. 17).
Now attach the brake handle to the brake line again. To do this, feed the brake line through
the loop on the brake handle until just before the knot (Fig. 18). Take the free end of the
brake line, loop it back and make it into a knot with the brake line.
Fig. 17: Brake line with knot at the mark
Fig. 18: Brake handle with brake line
To make the knot, feed the end of the brake line into the knot in the brake line following the
way the line is running (Fig. 19 to Fig. 21). By doing this, you will turn the single knot in the
line into a double knot which holds the brake handle firmly
.
Fig. 19: Make a knot
Fig. 20: Make a knot
Fig. 21: Make a knot
