25
⚠
WARNING
The surface of the airbag must not be
bent and must go smoothly around the
reserve. The reserve must be up as far as
possible so that
the airbag’s surface sits
neatly. Complete inflation can be affected
if the surface of the airbag has any bends.
Putting on the harness
Fig. 26 to Fig. 31 show how to put on the
harness.
First, pick up the harness and shake the
airbag open slightly to make it easier for it to
inflate later on.
Next, put on the harness, with your arms
going between the shoulder straps and the
adjustment for the back section.
Then do up both leg straps and the chest
strap. The buckles must be properly clicked
into place. Check that you have done this by
pulling firmly on each of them.
Finally, close the connecting strap between
the shoulder straps. The harness is now on
properly.
⚠
WARNING
Immediately before launch, check once
again whether the airbag has been pre-
inflated and that there is nothing which
could obstruct the vent during flight, to
ensure maximum protection during the
launch phase as well.
Fig. 26: Put on the harness
Fig. 27: Do up the right leg strap
Fig. 28: Do up the left leg strap
