Swing-N-Slide PB 5203, Assembly Instructions Manual

Page: 3 / 60

3
This product is intended for single family home/residential use only and not intended for use in any public setting.
Placement in any public setting constitutes a misuse of this product.
IMPORTANT!
Additional required safety installation instructions
According to ASTM requirements, all kits must be anchored to the ground and if the unit has a climbing rope, the rope must be anchored to the ground. If soil
conditions permit stakes to be pulled out easily, cementing into the ground is necessary.

To anchor the unit to the ground;
o
Follow the instructions included in this plan for applying Anchor-It devices to your unit or
o
Use a 2” x 4” x 18” (51mm x 102mm x 457mm) pressure treated stakes.
Pound stakes into ground at least 12” (305mm) at all inside corners of the posts (Including A-frame legs & climbing units posts).
Attach with four (4) 16d galvanized nails or 2-1/2” galvanized screws per stake into each post/A-frame.

If the unit has a climbing rope;
o
Anchor the rope end
Once the unit is completely assembled and before children are allowed to play on it, proper shock-absorbing surfacing material must be installed. This may be
accomplished by using loose-fi ll materials at a suffi cient depth. The Consumer Product Safety Commission “Handbook for Public Playground Safety” lists the fol-
lowing materials and required depths that are suffi cient for home/residential application.
For fall height protection up to 9 ft. (2.742m) [recommended for Swing-N-Slide kits]:
Loose Fill Material Required (Uncompressed) Depth
1
in(mm)
Wood Mulch 9” (229mm)
Double Shredded Bark Mulch 9” (229mm)
Uniform Wood Chips 12” (305mm)
Fine Sand 12” (305mm)
Fine Gravel 12” (305mm)
1 These depths were derived from the CPSC Handbook. Swing-N-Slide has not done independent tests to determine these required depths.
When properly installed, shock absorbing material will completely cover the horizontal baseboards on climbing units. This protective surfacing must extend a
minimum of 6 ft. (1.828m) in all directions from the perimeter of the equipment or from the outermost edges of any component. For example, a slide extending
beyond the platform must have protective surfacing at least 6 ft. (1.828m) out from both sides as well as the end. For swings, the protective surface must extend
at least 14 ft. (6m) out from both the back and front of the swing when the swing is in its rest position.
For further information on playground safety, the Consumer Product Safety Commission (CPSC) publishes
the Outdoor Home Playground Safety Handbook which can be downloaded for free from www.cpsc.gov.
An additional resource is the American Society of Testing and Materials (ASTM) Standard Consumer Safety
Performance Specifi cation for Home Playground Equipment (ASTM F1148).
Swing-N-Slide® MANUFACTURERS LIMITED WARRANTY
Swing-N-Slide® takes great pride in the quality and durability of our products. Our Manufacturer’s Limited Warranty provides confi dence and demonstrates our commitment to providing
quality residential playground products.
MANUFACTURER’S LIFETIME LIMITED WARRANTY
Swing-N-Slide® warrants its thermoformed slides and climbing mountains to be free from defects in workmanship and materials, under normal use and conditions, for the lifetime of the
product.
MANUFACTURER’S 5 YEAR LIMITED WARRANTY
Swing-N-Slide® warrants its Custom Ready-to-Build Play Set kits and accessories to be free from defects in workmanship and materials, under normal use and conditions, for a period of
5 years.
MANUFACTURER’S 5 YEAR LIMITED WARRANTY
Swing-N-Slide® warrants its No-Cut and Wood Complete Ready-to-Assemble Play Set kits against wood rot and termite damage, and to be free from defects in workmanship and
materials, under normal use and conditions, for a period of 5 years for structural wood components.
Cosmetic defects that do not affect the structural integrity of the product, or natural defects of wood such as warping, splitting, checking, twisting, shrinkage, swelling or any other
physical properties of wood that do not present a safety hazard, are not covered by this warranty.
MANUFACTURER’S ONE YEAR WARRANTY
Swing-N-Slide® warrants its canopy roofs and/or tarps, and Timber GLOVE lumber wrap to be free from defects in workmanship and materials, under normal use and conditions, for a
period of one year.
Swing-N-Slide® will repair, or at its discretion, replace any part within the stated warranty period which is defective in workmanship or materials. This decision is subject to verifi cation
of the defect upon delivery of the defective part to Swing-N-Slide® at 1212 Barberry Drive, Janesville, Wisconsin, 53545. Any part(s) returned to Swing-N-Slide® must have prior ap-
proved Return Authorization Number and proof of purchase, including the date of purchase. This warranty is valid only if the product is used for the purpose for which it was designed
and installed at a residential, single family dwelling. This warranty is void if the product is put to commercial or institutional use. This warranty does not cover (a) products which have
been damaged by acts of Nature, negligence, misuse, or accident, or which have been modifi ed or repaired by unauthorized persons; (b) the cost of labor; or the cost of shipping the
product, any part, or any replacement product or part.
Swing-N-Slide® DISCLAIMS ALL OTHER REPRESENTATIONS AND WARRANTIES OF ANY KIND, EXPRESS, IMPLIED, STATUTORY OR OTHERWISE, INCLUDING THE IMPLIED
WARRANTIES OF MERCHANTIBILITY AND FITNESS FOR A PARTICULAR PURPOSE. Swing-N-Slide® WILL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL
DAMAGES. This warranty is non-transferable and does not extend to the owners of the product subsequent to the original purchaser. Some states do not allow limitations on implied
warranties or exclusion of incidental or consequential damages, so these restrictions may not be applicable to you. This warranty gives you specifi c legal rights. You may also have
other rights, which vary from state to state.
This warranty also does not apply to:
• Structures not erected, maintained or inspected in conformance with Swing-N-Slide® installation plans
• Structures that have had parts added or substituted not in conformance with Swing-N-Slide® installation plans
• Parts that have been modifi ed, altered or misused
• Parts that have not been used as designed or intended
• Damage due to acts of Nature, vandalism, abnormal use or abuse as determined by Swing-N-Slide®
Meijer.com