4
Installation
This section details the process of installing the sleeve on a new pool being constructed.
Important: Please read and adhere to all guidelines and instructions before attempting to install the
sleeve. SwimShape, LLC is not responsible for improper installation of the sleeve.
It is the responsibility of the installer to ensure that the sleeve is installed in accordance with all
local building codes, including any grounding or bonding requirements.
Contact your local building inspector for details of any grounding requirements in your area.
The sleeve is designed to install in concrete or cement surfaces. Do not install on any other
surface type.
1. Determine the setback (distance from the pool edge) to install the sleeve (refer to TABLE 1 below).
Pool Edge
Pool Edge
PRODUCT
RECOMMENDED SETBACK
SETBACK RANGE
Pool-Up Bar
10.5”
10.5”
Pool Edge
10.5”
Sleeve
Sleeve
16.0”
16.0”
Pool Edge
Sleeve
Sleeve
QuikFire Pool Basketball Hoop
QuikSpike Pool Volleyball Set
10.5 inches to 18.0 inches
Note: The front of backboard
is even with the pool edge
when setback is 19.5 inches
from pool edge.
i
None
Maximum setback from the
pool edge is 10.5” if sleeve is
being installed for use with
the Pool-Up Bar.
i
10.5” - 18.0”
16.0”
16.0”
Pool Edge
Sleeve
Pool Edge
10.5” - 18.0”
Sleeve
10.5 inches to 18.0 inches
TABLE 1: Sleeve Setback
© 2019 | SwimShape, LLC