35
Hr
- An internal hardware error has been detected
Prr
- The Prr error message indicates a problem with the regulation probe. The system is constantly verifying if the tem
perature probe reading is within its normal limits.
HL
- The water temperature at the heater has reached 119
o
F (48
o
C).
Do not enter spa water.
FLO
- The system did not detect any water flow while the filtration pump was running.
UPL
- No low level configuration software has been downloaded into the system.
AOH
- The temperature inside the spa skirt is too high, causing the internal temperature in the spa pack to increase
above the normal limits.
OH
- The water temperature in the spa has reached 108
o
F (42
o
C).
Do not enter spa water.
TOPSIDE PANEL DISPLAY MESSAGES
STANDBY MODE
A press of the
SETTINGS
key brings you into the menu options. Use the
UP
and
DOWN
arrow
keys to highlight
STANDBY
. Press the
LIGHT
key and the following message will appear.
“All pumps off! Press Drain to drain spa”
This mode allows you to stop all outputs including all automatic functions such as a filter cycle, heating
requests and smart winter mode purging for 30 minutes to perform quick spa maintenance.
DRAIN MODE
If you wish to put your spa into “
DRAIN MODE
” press the
FUNCTION
key beside the word “
Drain
” on
the display. Once you do that the display will indicate “
Drain in progress
”. The filtration pump will turn on
and run for 60 minutes.
In order to exit this mode, press the
FUNCTION
key beside the back arrow once to exit
DRAIN MODE
.
This will put you back into
STANDBY MODE
and if you wish to exit that press the same key to go back
to the main screen.