SANDFILTERSYSTEM PRO CLASSIC basic (DK,SE,UK,FI,NO,PL)
23
Swim & Fun Scandinavia ApS – [email protected] – www.swim-fun.com
4.1
Filter installation
Insert the tube with the manifold (6) in the tank (Fig. 3) and screw the small sand guard filters (7) to the manifold (Fig. 4). Place
the completed manifold in the middle of the tank and fill ¼ with water to stabilize the tank and make sure
that sand grains
sets in the filters during filling.
Place the spigot (9) on the mouth of the container, to provide sand getting into the manifold during filling, and make
sure that tube is centered on the manifold. Fill ¾ with sand (Fig. 5).
Remove the spigot, clean the filter mouth carefully and insert the 7-way valve (2) making sure there is no sand in the tank. (Fig.
6) Insert the gasket (3) and tighten the fastening screws (Fig. 7).
The filter is now ready.
