1
2.7 Hexadecimal Printing
Turn on the printer according to the step below, it will enter the mode of Hexadecimal
Printing
1.Open the cover;
2.Hold down
【
FEED
】
button,and connect with power; wait for the alarm and close the
paper cover.
3.The printer will print out 3 lines as below:
Hexadecimal Dump
To terminate hexadecimal dump,
Press FEED button three times.
This means the printer has entered hexadecimal printing mode, and under this mode,
all of the input will be printed out as hexadecimal number, feed one line with
single-click of “FEED” button, after 3 times, it will print out “*** Completed ***”, and
exit hexadecimal printing mode.
2.8 Parameter Setting
There are two ways to set printer parameters:
1. Use the setting tool on the PC side for setting.
2. Set by the button, the specific operation method is as follows.
In the shutdown state, first open the [paper compartment cover], press and hold the
[FEED] key, then turn on the power switch, and release the [FEED] key after the
status indicator and the out of paper indicator flash alternately. Press the [FEED] key
twice, and then close the [paper compartment cover]. The printer enters the
parameter setting mode, and prints out the first settable parameter and its current set
value. Please refer to Appendix A for detailed setting methods.
Exit the parameter setting method: first open the [paper compartment cover], then
press and hold the [FEED] key, then close the [paper compartment cover] and
release the [FEED] key to save the set parameter value and exit the parameter
setting mode. Enter normal working mode.
If the printer is turned off directly, the set parameter values will not be saved.
Note: STR860E does not support button setting.
