11
as this will surely scratch or otherwise mar the surface of the glass.
The finish of the microscope is hard epoxy and is resistant to acids and
reagents. Clean this surface with a damp cloth and mild detergent.
Periodically, the microscope should be disassembled, cleaned and
lubricated. This should only be done by a qualified, authorized
microscope technician.
DUST COVER AND STORAGE – All microscopes should be protected from
dust by a dust cover when in storage or not in use. A dust cover is the
most cost-effective microscope insurance you can buy. Ensure that the
storage space is tall enough to allow the microscope to be placed into
the cabinet or onto a shelf without making undue contact with the
eyepieces. Never store microscopes in cabinets containing chemicals,
which may corrode your microscope. Also, be sure that the objectives
are placed in the lowest possible position and the rotating head is turned
inward and not protruding from the base. Microscopes with mechanical
stages should be adjusted toward the center of the stage to prevent the
moveable arms of the mechanical stage from being damaged during
storage in the cabinet.
BULB REPLACEMENT
M7000C LED Illumination
The Swift M7000C base is equipped with a 3.4 volt, .06 watt illumination
system. The LED for this illumination system has approximately 100,000
hours of service. The time may vary depending on use and intensity. To
prolong the life of the LED, you should always turn off the unit when not
in use.
When purchasing replacement LEDs, it is important that you use only the
Swift approved LED (Swift # MA2215). This LED has been tested and
approved for life span, color temperature and brightness.
To replace an LED, you must first make sure the microscope is turned off.
Use the allen wrench (.09mm) that was included with the microscope to
loosen the set screws that hold the black plastic illuminator housing onto
the base of the microscope. Remove the illuminator housing to expose
the LED. Simply pull the LED straight up to remove it from the light
socket. Align the 2 metal socket pins with the holes at the bottom of the
new LED and push the LED onto the socket. Re-install the illuminator
housing.
