ASSEMBLY AND OPERATION
Before Initial Operation
Unpack the garden tool and accessories and check that no
parts are missing or damaged.
NOTE:
The batteries (optional; depending on delivery
scope) are not fully charged on delivery. Prior to initial
operation, charge the batteries fully. See user manual of
the battery charger.
Safety Key
The unit has a security key. The key is located
under the battery cover. By removing the key,
the power supply to the motor is interrupted.
Remove the safety key:
a.)
if the unit is left unattended;
b.)
before checking, cleaning or performing other work
on the unit;
c.)
before removing blockages;
d.)
if a foreign object is hit;
e.)
if the unit starts vibrating excessively.
Check the lawnmower for damage, and have any damage
repaired at a qualified technician or a service centre.
To remove the key, press the lock (1) and pull out the safety
key (2).
To insert the safety key, press down the key until it clicks.
Assembly
Attaching The Handle Bar
CAUTION: When collapsing or unfolding the handlebar, the
cable may be damaged. Ensure that the cable is not kinked
1. Place the lower handle into the slot (1).
2. Align the holes. Fasten the screws as illustrated (2).
3. Place the upper handle on the lower handle.
4. Attach the upper handle.
5. Insert the threaded bolt through the holes un the
upper handle and lower handle.
6. Fasten the screws and knobs.
7. Attach the cable with the cable clamp.
Assembling the Grass Catcher
1. Insert the two lower parts together until it clicks (1).
2. Put on the upper part and press it together until it
clicks. (3).
Attaching the Grass Catcher
1.
Lift the discharge flap. (1).
2.
Remove the mulching plug.
3.
Hook the grass catcher bag into the lawnmower (2).
4.
Fold the discharge flap down again (3).
Adjusting the Cutting Height
The cutting height can be adjusted from 0.79
” to 2.36”.
1. Pull the handle outwards slightly.
2. Set the required cutting height.
3. Release the lever again.
Inserting/Replacing the Battery
Ensure that the battery is fully charged before inserting it
into the tool.
1. Charging the battery as described in the user manual
of the charger
2. Open the battery cover (1).
3. Press the charged battery into the power tool until it
clicks into place (2).
4. Close the battery cover (3).
