13
TR 600P / TR 750P / TR 950P / TR 1150P
2/3
1
2
3
4
D
ok
: 101502B
-GB 1442
When taking a break
Stop the machine during breaks.
During all breaks you must put the machine away
so there is no risk for unintentional start.
OPERATING NEAR EDGES
When operating along edges, at least 2⁄3 of the
machine must be on a surface with full bearing
strength, otherwise the machine can tip over.
Switch off the machine and lift it back on
surface with full bearing strength.
NOTICE When operating the machine, follow
the instructions in the manual; never sit or stand
on the machine when it is working.
WARNING Overturning hazard
Service and maintenance
1; Loosen the nuts and screws (1) from the blade
shafts (2)
2; Pull out the blade shafts (
2
) from the hub.
3; Clean the contact surfaces on the blade shafts
(
2
) and the hub.
4; Grease the surfaces and assemble the blade
shafts (
2
) again.
5; Bring together the blade shafts (
2
) and finish
the procedure by greasing the nipples (
3; 4
) until
grease is coming out around the blade shafts.
Cleaning the pressure plate
Check the status of the lubrication of the bearings.
Use the same grease as for the shafts.
1; Loosen and remove the screw and the
washer.
2; Dismount the spider assembly. Use a puller if
the blade cross is tight on the shaft.
3; Dismount the pressure plate, ball bearing, slide
bush and bearing plate.
4; Clean the surfaces and grease them carefully.
5; Assemble the parts.
NOTICE The gear box of the trowel is
lubricated for life. If the oil for some reason has
to be changed, use recommended oil quality. See
section ”Technical data”.
