How To Use Hemmer Component
Rotating Arm
Clamping Handle
AFTER THE PANEL IS NOTCHED AND CUT
1. Slide notched panel down to the hemmer station.
2. Make sure the station is set to the appropriate slope.
3. Slightly lift the operator handle at the top to allow the panel to hit the back of the fencing of the hemmer bar.
4. Clamp panel by pulling the handle in a downward position until you feel it lock into place.
5. Grab rotating handle and move in a circular motion. The panel is now hemmed.
6. Unwind rotating handle back towards the original position.
7. Slide panel off hemming die and move forward through hemmer.
*If you would like a tighter hem, return the hemmed panel to the hemming station and press down with the hemming bar.
ADJUSTABLE SHOES
The shoes allow for even amount of pressure across the panel for the perfect hem. These shoes should be adjusted depending
on the length of the hem you are trying to create.
TO ADJUST SHOES
All that is needed is an allen wrench. Loosen the nuts to slide the shoes around. To completely remove the shoes, remove the
nuts and pull the shoes off.
ROTATING TABLETOP
Tabletops can be rotated 180 degrees for a trailing edge hem. Just unclamp the vice grip and re-clamp when you’ve reached
the desired angle.
Maximum Hemming Angle - 60 inches