Sweepster VRS Series, Manual, Page: 9 / 54

9
Run the prime mover and sweeper at a low idle.
check for hydraulic leaks or other problems and
make corrections, if necessary, before using the
sweeper.
WaRNiNG - aVOiD SeRiOUS iNJURy. check
for large objects that could harm the
operator or others if thrown by the
sweeper. Remove these items before
operating.
During Use
carry the sweeper low to the ground so that the
operator has good visibility and stability. Avoid any
sudden movements from one side to the other side
when you carry a sweeper.
Avoid excessive downward pressure on the brush
sections to prevent excessive wear. A two to six
inch wide pattern is sufficient for most applications.
ensure that the motor and bearing plates are
equally adjusted in order to prevent an uneven wear
pattern.
Directing Debris
observe wind direction. Sweeping with the wind
makes sweeping more effective and helps keep
debris off the operator.
the terms swing and angle are used
interchangeably.
NOTiCe - aVOiD SWeePeR DaMaGe.
Reduce travel speed to avoid hitting
immovable objects.
•before leaving the operators area for any
reason, lower the sweeper to the ground. Stop
the prime mover engine, set the brakes and
remove the key from the ignition.
•Minimize flying debris - use the slowest rotating
speed that will do the job.
•Keep hands, feet, hair and other loose clothing
away from all moving parts.
•Leave the brush hood (shield) and all other
shields and safety equipment in place when
operating the sweeper and primer mover.
•be aware of extra weight and width a sweeper
adds. Reduce travel speed accordingly.
•Leave the brush hood (shield) and all other
shields and safety equipment in place when
operating the sweeper.
•when sweeping on rough terrain, reduce speed
to avoid “bouncing” the sweeper. Loss of
steering can result.
•Never sweep toward people, buildings, vehicles
or other objects that can be damaged by flying
debris.
•only operate the sweeper while you are in the
seat of the prime mover. the seat belt must be
fastened while you operate the prime mover.
only operate the controls while the engine is
running. Protective glasses must be worn while
you operate the prime mover and while you
operate the sweeper.
•while you operate the sweeper slowly in an
open area, check for proper operation of all
controls and all protective devices. Note any
repairs needed during operation of the sweeper.
Report any needed repairs.
before each Use
Perform daily maintenance as indicated in
Maintenance Schedule.