Swecoin TTP 2000, Service Manual

Page: 21 / 47

Repair
0701 TTP 2000 Kiosk Printer–Service Manual 21
6.4 Cutter
6.4.1 Removing the moving blade
Rotate the cogwheel with your fingers so that the cutter comes to it’s top position.
Grab the blade, tilt it slightly forwards and lift it up form the cutter linkage and take it out.
6.4.2 Fitting a new blade
Use Vaseline spray to lubricate the face of the cutter blade where the cutter spring
(arrows) touches the blade before putting the table back.
Insert the blade in the slots of the cutter linkage.
Tilt the blade backwards gently and turn the cogwheel so that the blade goes down. Make
sure that the tab on the blade enters the hole in the control board.