SPECIFIC SAFETY RULES
SW1891
04
1. Accessories must be rated for at least the speed recommended on the tool warning label.
Wheels and other accessories running over rated speed can fly apart and cause injury.
2. Hold tool by insulated gripping surfaces when performing an operation where the tool may
contact hidden wiring or its own cord. Contact with a “live” wire will make exposed metal parts
of the tool “live” and shock the operator.
3. Check the backing pad carefully for cracks, damage or deformity before operation. Replace
cracked, damaged or deformed pad immediately.
4. NEVER use the tool with wood cutting blades or other sawblades. Such blades when used on
a polisher frequently kick and cause loss of control leading to personal injury.
5. Hold the tool firmly.
6. Keep hands away from rorating parts.
7. Make sure the abrasive disc or wool bonnet is not contacting the workpiece the switch is
turned on.
8. When sanding metal surfaces, watch out for flying sparks. Hold the tool so that sparks fly away
from you and other persons or flammable materials.
9. Do not leave the tool running. Operate the tool only when hand-held.
10. Do not touch the workpiece immediately after operation; it may be extremely hot and could
burn your skin.
11. Check that the workpiece is properly supported.
12. Pay attention that the wheel continues to rotate after the tool is switched off.
13. This tool has not been waterproofed, so avoid the us of EXCESSIVE WATER on the work
piece surface.
14. Ventilate your work area adequately when you perform sanding operations.
15. Use of this tool to sand some products, paints and wood could expose user to dust containing
hazardous substances, Use appropriate respiratory protection.
DO NOT let comfort or familiarity with product (gained from repeated use)
replace strict adherence to polisher safety rules. If you use this tool unsafely or
incorrectly, you may suffer serious injury.
SPECIFIC SAFETY RULES
The followings show the symbols used for the tools.
V
A
Hz
~
n
o
.../min
VOLTS
AMPERES
HERTZ
ALTERNATING CURRENT
NO LOAD SPEED
REVOLUTIONS PER MINUTE
............................................
............................................
............................................
............................................
............................................
............................................
