Swarovski Optik 5590049, User Manual

Page: 15 / 101

dG / DE
28
dG / DE
29
dG / EN dG / EN
3. Once the code has been scanned and accepted, Live
View is activated and visible in the dG app. It can be trans-
mitted on up to five devices.
4.5 TAKING A PHOTO
To take a photo, briefly press the
release button once. Hold the device
as still as possible while taking the
picture, as taking and transmitting the
photo involves a slight delay. The
camera focuses during this time, then
an acoustic signal confirms the photo has been taken after
1–1.5 seconds. The image is then instantly transmitted to your
smartphone/tablet.
Note:
The dG can store up to ten images, provided there is an active
Wi-Fi connection between the dG and the smartphone/tablet.
If the connection to the dG app or another dG-compatible app
is interrupted (e.g. because the app has been closed), up to ten
images will be stored temporarily. As soon as the app is ope-
ned again, the images will be transferred to the app.
4.6 AUTOMATIC SWITCH-OFF
The dG switches itself off automatically after about five minutes
if there is no active Wi-Fi connection to a smartphone/tablet.
After 15 minutes of complete inactivity, the dG also switches
itself off automatically.
4.7 BATTERY STATUS
You can check the battery status in switched-off mode by briefly
pressing the release button. In switched-on mode, the battery
status stays permanently lit up. Depending on the battery status,
three (battery full) to one (battery low) LED lights go on. If the
battery status falls below 10%, the status LED flashes red and a
charge notification is displayed in the dG app. Once it drops
below 5%, the dG switches off.
If the status LED blinks red and all 3
battery status LEDs flash, the battery is
too low (<5%) and the device cannot
be switched on (see section 4.9 Error
messages). If the battery is complete-
ly discharged, the battery status LED
no longer lights up. In this instance, please recharge the dG.
Note:
When the battery is completely discharged, all three battery
status LEDs flash at the start of the charging process (for
approx. one minute).
4.8 STATUS DISPLAYS
Status LED What it means
Flashing orange The dG has been switched on and is starting
up
Flashing green The dG is ready to be connected to a mobile
device
Permanently green The dG is connected to a smartphone/tablet
Alternating green/orange The dG’s memory is full (max. ten images) –
open the dG app to transfer images
Flashing blue Firmware update is in progress
Flashing red Battery status low (<10%)
4.9 ERROR MESSAGES
Status LED What it means
Alternating red/blue Operating temperature too low
(<-20°C/-68°F)
Alternating red/orange Operating temperature too high (battery
>60°C/140°F or system >80°C/176°F)
Permanently red Critical firmware error
Status LED +
battery status LEDs
What it means
Status LED flashing red +
all three battery status LEDs
blinking
Battery status too low (<5%), device cannot
be switched on. Please charge the dG.