1.1.4 FCC ID:
The FCC ID for the Swarm M138 Modem is
2AVE9-M138
. All manufacturers integrating the
Swarm M138 Modem into their products are required to provide a physical or e-label stating
“Contains FCC ID:
2AVE9-M138
”.
1.1.5 Part 15 Subpart B Disclaimer:
The final host product requires Part 15B compliance testing with the modular transmitter
installed.
1.2 ISED Compliance
1.2.1 ISED RSS-Gen Notice CAN ICES-3 (B)NMB-3(B):
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1) l’appareil ne doit pas produire de brouillage;
2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
1.2.2 IC ID:
The IC ID for the Swarm M138 Modem is
25817-M138
. All manufacturers integrating the Swarm
M138 Modem into their products are required to provide a physical or e-label stating “Contains
IC ID:
25817-M138
”.
1.3 RF Exposure Guidance
In order to comply with FCC / ISED RF Exposure requirements, this device and antenna must
be installed to provide at least 36 cm separation from the human body at all times.
Afin de se conformer aux exigences d'exposition RF FCC / ISED, cet appareil doit être installé
pour fournir au moins 36 cm de séparation du corps humain en tout temps.
© 2022 SWARM TECHNOLOGIES
SWARM M138 MODEM PRODUCT MANUAL · REV 1.20 · FEBRUARY 2022
PAGE
8
