Security Made Smarter
QUICK START GUIDE
1080p Pan & Tilt
Wi-Fi Camera
Limited Warranty Terms & Conditions
Swann Communications warrants this product against defects in workmanship and material for a period of one (1) year from its original
purchase date. You must present your receipt as proof of date of purchase for warranty validation. Any unit which proves defective during the
stated period will be repaired without charge for parts or labour or replaced at the sole discretion of Swann. The end user is responsible for
all freight charges incurred to send the product to Swann’s repair centres. The end user is responsible for all shipping costs incurred when
shipping from and to any country other than the country of origin.
The warranty does not cover any incidental, accidental or consequential damages arising from the use of or the inability to use this product.
Any costs associated with the fitting or removal of this product by a tradesman or other person or any other costs associated with its use are
the responsibility of the end user. This warranty applies to the original purchaser of the product only and is not transferable to any third party.
Unauthorized end user or third party modifications to any component or evidence of misuse or abuse of the device will render all warranties
void.
By law some countries do not allow limitations on certain exclusions in this warranty. Where applicable by local laws, regulations and legal
rights will take precedence.
FCC Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Simplified EU Declaration of Conformity
Swann Communications declares that this device is in compliance with the essential requirements and other relevant provisions of Directive
2014/53/EU. A copy of the Declaration of Conformity can be found at: www.swann.com/uk/compliance
Correct Disposal of this product.
This marking indicates that this product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection
systems or contact the retailer where the product was purchased. They can take this product for environment safe recycling.
QSGPTCAMVER3E | © Swann Communications 2018
Light Sensor
Detects ambient light
and turns on the infrared
LEDS for night vision, if
necessary
Speaker
Ethernet Port
Used for wired
connection/setup
Reset Button
Hold for 10 seconds
to perform a factory
reset. This will reboot
the camera and clear
all settings to factory
defaults, including
previously configured
Wi-Fi settings, so you
can set up your camera
again, if needed
USB Power Port
Restarting your camera
can sometimes quickly
resolve a problem—just
disconnect the USB cable,
and then plug it back in
MicroSD Card Slot
Never miss the moment—Put in a
microSD card to record and save
motion-activated events
Power LED
Threaded
Mounting Hole (Bottom)
Prefer to mount your camera?
Just attach the included
mounting bracket to the wall,
then line the threaded hole on
the bottom of the camera up
with the threaded stud on the
mounting bracket and tighten
the knob to secure the camera
Connected state
ON
Unconnected state
OFF
Wi-Fi LED
Microphone
Infrared LEDS
Dual-Band
Wi-Fi Antenna
Getting to know your Pan & Tilt Wi-Fi Camera
ENGLISH
NEED HELP?
support.swann.com
