background image

5

6

Limited Warranty - Terms & Conditions

FCC Verification

Swann Communications warrants this product against defects in workmanship and material for a period 

of one (1) year from its original purchase date. You must present your receipt as proof of purchase for 

warranty validation. Any unit which proves defective during the stated period will be repaired without 

charge for parts or labour or replaced at the sole discretion of Swann. The end user is responsible for 

all freight charges incurred to send the product to Swann’s repair centres. The end user is responsible 

for all shipping costs incurred when shipping from and to any country other than the country of origin. 

The warranty does not cover any incidental, accidental or consequential damages arising from the use 

of or the inability to use this product. Any costs associated with the fitting or removal of this product 

by a tradesman or other person or any other costs associated with its use are the responsibility of the 

end user. This warranty applies to the original purchaser of the product only and is not transferable to 

any third party. Unauthorized end user or third party modifications to any component will render all 

warranties void. By law some countries do not allow limitations on certain exclusions in this warranty. 

Where applicable by local laws, regulations and legal rights will take precedence.
For Australia: Our goods come with guarantees which cannot be excluded under Australian Consumer 

Law. You are entitled to a replacement or refund for a major failure and for compensation for any other 

reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if 

the goods fail to be of acceptable quality.

MH856CAM180416E | © Swann 2016

This equipment has been tested and found to comply with the limits for Class B digital device, pursuant 

to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 

harmful interference in a residential installation. This equipment generates, uses and can radiate radio 

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 

interference to radio communications. However, there is no guarantee that interference will not occur 

in a particular installation. If this equipment does cause harmful interference to radio or television 

reception, which can be determined by turning the equipment off and on, the user is encouraged to try 

to correct the interference by one of the following measures:
• 

Reorient or relocate the receiving antenna

• 

Increase the separation between the equipment and the receiver

• 

Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected

• 

Consult the dealer or an experienced radio/TV technician for help

These devices comply with part 15 of the FCC Rules. Operation is subject to the following two conditions: 
• 

These devices may not cause harmful interference, and 

• 

These devices must accept any interference received, including interference that may cause 

undesired operation.

HD Dome

Security Camera

For use with Swann 1080p DVRs

EN

INSTRUCTION MANUAL

Helpdesk/Technical Support

Technical Support E-mail: 

  

[email protected]

Telephone Helpdesk

USA 

   1-800-627-2799

USA Parts & Warranty 

 1-800-627-2799

    (M-F, 

9am-5pm 

US 

PT)

AUSTRALIA

 

 

 

1800 788 210 

NEW ZEALAND 

 

 

0800 479 266 

UK 

 

   0808 168 9031

Security Made Smarter

Important Note: 

All jurisdictions have specific laws and regulations relating to the use of cameras. Before 

using any camera for any purpose, it is the buyer’s responsibility to be aware of all applicable laws and 

regulations that prohibit or limit the use of cameras and to comply with the applicable laws and regulations.

WARNING: 

Modifications not approved by the party responsible for compliance could void user’s 

authority to operate the equipment.

Reviews: