![Swann SW-P-HSK Install Manual Download Page 3](http://html.mh-extra.com/html/swann/sw-p-hsk/sw-p-hsk_install-manual_1412276003.webp)
Use the diagram over the page as a guide during installation of the cameras.
Step 1:
At the end of your Twin Value Pack Camera cable you will find three colored plugs:
•Yellow (Video RCA)
•Red (Audio RCA)
•Black
Step 2:
Plug the
yellow
RCA plug (1) into the
"Video In"
input (3) (usually located at the back
of your TV or VCR).
Step 3:
Plug the
Red
RCA plug (2) into the
"Audio In"
input (4) (usually located at the back of
your TV or VCR).
Step 4:
Connect the
black
plug (5) at the end of your Twin Value Pack into the
black
plug at the
end of the
power adaptor
(6).
Step 5:
Plug the
power adaptor
(6) into the mains power point in your wall.
Step 6:
If you have an
AV TV
with RCA sockets you will need to switch the
TV
to the
AV
channel on your
TV
to view the camera. To connect the Twin Value Pack Camera to your
VCR
, you will need to turn the
VCR
to the
AV Input
selection and turn your
TV
onto
the channel you would normally use to view a tape or movie on your
VCR
. The AV
Channel on your
TV
or
VCR
may be activated by a button on your remote that is marked
with this symbol , or
L
1
or
L2
or possibly
AV
1
or
AV2
.
Note:
Please read the
instructions
for your
VCR
or
TV
for more information on using their
AV inputs.
Step 7:
If the picture is not clear, you will need to undo the small grub screw that locks the lens in
place, which is located on the side of the barrel that the lens screws in to. Focus the
camera by turning the lens in a
clockwise
or
anti-clockwise
direction until the image
is clear, then re-tighten the small grub screw.
You should position your cameras to cover the areas most exposed to risk. See
our suggestions below for some ideas:
Take note that the Twin Value Camera will require a waterproof housing to
protect it from the elements if used outdoors. Direct exposure to the effects of
the weather will void the warranty.
Where to Place The Security Stickers:
1. On your front window
2. On side windows
3. Near entrance points - doors, gates
4. Next to a dummy camera mounted outside
5. On the front counter
6. On the cash register
7. Next to an obvious camera
Design of sticker subject to
change without notice.
1. Doorways
5. Reception
areas
6. Cash
register
7. Mix
dummies
& real
cameras
8. Under eaves
2. Windows
3. Car Parks
4. Verandahs
6
3
Tips for locating your camera
Connect the Camera to your monitoring device